LG HCS5650 Operation Guide - Page 8
The HCS5650 Integrator Box as well as LCD monitorsM3701C-BH and M4201C-BH generate heat
View all LG HCS5650 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
Ventilation The HCS5650 Integrator Box as well as LCD monitors(M3701C-BH and M4201C-BH) generate heat during operation and need to be provided with adequate ventilation to assure continued reliable operation. See recommendations below. Ventilation Clearance Proper clearance for air to flow around the HCS5650 Integrator Box must be provided. Monitor Ventilation Be sure proper ventilation is provided for the monitor, see monitor installation guide for specified ventilation requirements. 1 There are ventilation holes on four sides of the the HCS5650 box provided for ventilation cooling. a. If the box is mounted vertically, the vents on the sides should be located on the top and bottom for free vertical air movement. b. If the box is mounted horizontally, the vents should be located at the sides and top of the enclosure (never mount the box with vents facing down). 2 The vent holes should never be blocked or obstructed to airflow but have an unimpeded path through any enclo- sure back to room temperature air. 3 The unit and its venting, should not be installed near heat sources such as radiators or heating ducts. 4 If the unit is placed in an enclosure, tests should be run to confirm that the ambient temperature around the unit under normal expected operating conditions is stable and does not exceed 40 degrees Celsius (104F). This can be determined by placing a thermometer near the air intake vents in the proposed enclosure and measuring the temperature every hour, under normal operating conditions, until two successive readings repeat. If temperature does not stabilize but keeps increasing above 104F, ventilation is inadequate and needs to be improved. 5 Always provide adequate air space between the ventilation areas and adjacent structures. Vent Holes Vent Holes Vent Holes Vent Holes *Note: In addition to the ventilation requirements shown, be sure to allow enough clearance (4" - 5") for wiring clusters attached to the Integrator Box. Vent Holes Vent Holes PAGE 8