Lenovo ThinkPad W701 Hardware Maintenance Manual - Page 108
VGA thermal device/fan and thermal putty
View all Lenovo ThinkPad W701 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 108 highlights
Table 33. Installation of the CPU thermal device/fan for W701 and W701ds When installing: • Before you attach the fan assembly to the computer, apply thermal grease, at an amount of 0.2 grams, on the part marked a as in the following figure. Either too much or too less application of grease can cause a thermal problem due to imperfect contact with a component. a • Make sure that the fan connector is attached firmly. 1180 VGA thermal device/fan and thermal putty Note: In ThinkPad W701 and W701ds, thermal putty is used between the thermal device/fan and the video card. The thermal putty is included in the video card FRU, but is not included in the thermal device/fan FRU. If once you remove the thermal device/fan, you need to attach new thermal putty on the video card before you reinstall the thermal device/fan. Order the thermal putty FRU when you service the thermal device/fan. ThinkPad W700 and W700ds do not have this thermal putty. For access, remove these FRUs in order: • "1010 Battery pack" on page 68 • "1040 Hard disk drive (HDD) cover, HDD and HDD rubber rails or solid state drive (SSD) and storage converter" on page 70 • "1060 Palm rest or palm rest with fingerprint reader" on page 75 • "1090 Keyboard" on page 80 • "1120 DIMM slot cover and DIMM under keyboard for W701 and W701ds" on page 86 • "1130 Keyboard bezel and speaker assembly" on page 88 Table 34. Removal steps of VGA thermal device/fan Note: Loosen the screws 1 , 2 , 3 , and 4 , but do not remove them. When you attach the fan, secure the screws in order as shown in this figure. For ThinkPad W700 and W701: 102 ThinkPad W700, W700ds, W701, and W701ds Hardware Maintenance Manual