Lenovo ThinkPad W701 Hardware Maintenance Manual - Page 51
Numeric error codes, For a device not supported by diagnostic codes in the ThinkPad Notebooks
View all Lenovo ThinkPad W701 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 51 highlights
Note: For a device not supported by diagnostic codes in the ThinkPad Notebooks, see the manual for that device. Numeric error codes Table 2. Numeric error codes Symptom or error FRU or action, in sequence 0175 System board. Bad CRC1, stop POST task-The EEPROM checksum is not correct. 0176 System Security-The system has been tampered with. 1. Run BIOS Setup Utility, and save the current setting by pressing F10. 2. System board. 0177 Bad SVP data, stop POST task-The checksum of the supervisor password in the EEPROM is not correct. System board. 0182 Bad CRC2. Enter BIOS Setup and load Setup defaults.-The checksum of the CRS2 setting in the EEPROM is not correct. 1. Run BIOS Setup Utility. Press F9, and Enter to load the default setting. Then save the current setting by pressing F10. 2. System board. 0185 Bad startup sequence settings. Enter BIOS Setup and load Setup defaults. 1. Run BIOS Setup Utility. Press F9, and Enter to load the default setting. Then save the current setting by pressing F10. 0187 EAIA data access error-The access to EEPROM is failed. System board. 0188 Invalid RFID Serialization Information Area. System board. 0189 Invalid RFID configuration information area-The EEPROM checksum is not correct. System board. 0190 Critical low-battery error 1. Charge the battery pack. 2. Battery pack. 0191 System Security-Invalid Remote Change requested. 1. Run BIOS Setup Utility, and then save current setting by pressing F10. 2. System board. 0192 System Security- Embedded Security hardware tamper detected. System board. 0193 RF antenna has been removed Enter the supervisor password. 0194 Enter the supervisor password. The computer has been carried through a security gate 0195 Security hardware tamper detected 1. Enter BIOS Setup Utility by entering supervisor password, and select Password ➙ Security Chip ➙ Clear Security Chip to clear this error. 2. Security chip. 3. System board. Chapter 4. Related service information 45