Marantz NR1602 NR1602N_ENG_CD-ROM_v00 - Page 114
Operating learn function, Learning procedure - av
View all Marantz NR1602 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 114 highlights
Basic version Advanced version Operating learn function • This remote control unit is capable of learning and storing codes used by other remote controls that you already own. • If the AV device is not a marantz device, or if the device does not operate even when the preset code is registered, use the learning function. Remote codes for different devices can be remembered for use by the marantz remote control included with this device. • This remote control unit is capable of learning around 60 codes. Learning procedure 1 Place the marantz remote control and remote control from the other device approximately 5 cm apart, with the remote control signal transmission sections facing each other. 5 cm 2 Press and hold down SET and SURROUND until the LEARN indicator blinks. 3 Press input source select buttons (BD, DVD, SAT, TV, or CD) to select the input source. 4 Select the button to be learned. The LEARN indicator lights. NOTE • The learning function is unavailable for all SOURCE Z /X and DISP in any mode. • The learning function is unavailable for all buttons in TUNER mode, NET/USB mode and AMP mode. 5 Press and hold the button of the original remote control unit to be learned until the SEND indicator blinks twice. • When the SEND indicator blinks once again, the transmitting code is unavailable for remote control unit, or the transmitting signal has been interrupted by noise. • If the SEND indicator blinks once, repeat this step. • When the memory of the remote control unit is full, the LEARN and SEND indicators blink once. If you want to learn the code, you need to erase a different learned button. NOTE If the LEARN indicator flashes when the SEND indicator is lit, then the button cannot be learned. 6 Repeat steps 4 and 5 to learn other buttons for the same input source. 7 Repeat steps 3 to 6 to learn other input sources. 8 When programming of the remote control unit is completed, press SET. The LEARN display disappears, and the remote control unit exits learn mode. NOTE • The learning function is unavailable for all buttons in TUNER mode, AMP mode, NET/USB mode and M-XP mode. • The learning procedure does not operate correctly if the batteries have become worn. • If no buttons are pressed for approximately 1 minutes while in the LEARN mode, the remote control unit automatically exits from the LEARN mode. Information 111