Marantz NR1602 NR1602N_ENG_CD-ROM_v00 - Page 64
Connections (Advanced connection), Connecting the remote control connectors
View all Marantz NR1602 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 64 highlights
Basic version Advanced version Connections (Advanced connection) Connecting the remote control connectors RC OUT w IR receiver REMOTE CONTROL q IN OUT CD recorder EXTERNAL INTERNAL REMOTE CONTROL IN OUT DVD player EXTERNAL INTERNAL REMOTE CONTROL IN OUT CD player EXTERNAL INTERNAL q You can control other marantz products through this unit with the remote control unit by connecting the REMOTE CONTROL connectors on each unit. • The signal transmitted from the remote control unit is received by the remote sensor on this unit. Then the signal is sent to the connected device through REMOTE CONTROL connector. Therefore you need to aim the remote control only at the this unit. • Set the remote control switch located on the rear panel of the connected audio component to "EXTERNAL" or "EXT." to use this feature. • If a marantz power amplifier (excluding certain models) is connected to any of these connectors, the power of the power amplifier switches to on/standby in conjunction with the ON/STANDBY button of the this unit. w Whenever external infrared sensors or similar devices are connected to REMOTE CONTROL IN connector of the this unit, be sure to always disable operation of the infrared sensor on the this unit (vpage 105 "Remote control settings"). NOTE Be sure to set to "enable" when external infrared sensors or similar devices are not connected. Otherwise, the unit will be unable to receive remote control commands. Information 61