Marantz NR1602 NR1602N_ENG_CD-ROM_v00 - Page 20
Preparation, Detect & Measure Main, ENTER - subwoofer
View all Marantz NR1602 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 20 highlights
Basic version Advanced version STEP 1 Preparation Set up speakers (Audyssey® Auto Setup) STEP 2 Detect & Measure (Main) 4 Connect the setup microphone to the SETUP MIC jack of this unit. When the setup microphone is connected, the following screen is displayed. Audyssey Auto Setup MultEQ Preparation Connect the speakers and place then according to the recommendations in the manual. Next [ENTER] Enter [RETURN] Cancel 5 Select "Next" and then press ENTER. 6 Use ui to select "Auto Setup Start" and then press ENTER. Audyssey Auto Setup Preparation Set the following items if necessary. MultEQ Amp Assign Channel Select Auto Setup Start [ENTER] Enter [RETURN] Cancel Here, we explain setup using the example of 7.1-channel speaker playback using surround back speakers. For setup of surround speaker systems other than 7.1-channels, follows steps 4 and 5 in "Set up "Amp Assign"" (vpage 59). . If unused channels are set with "Channel Select", measuring time can be shortened. For setting, perform steps 7 to 10 of "Set up "Channel Select"" (vpage 60). • In STEP 2, you will perform measurements at the main listening position. • This step automatically checks the speaker configuration and speaker size, and calculates the channel level, distance, and crossover frequency. It also corrects distortion in the listening area. 7 Select "Measure" and then press ENTER. When measuring begins, a test tone is output from each speaker. • Measurement requires several minutes. 8 The detected speakers are displayed. • The illustration below shows an example of when the front speakers, center speaker, subwoofer, and surround speakers have been detected. Audyssey Auto Setup Detect Check Front Center Subwoofer Surround S.Back Yes Yes Yes Yes Yes 2spkrs Retry Next Measure [ENTER] Enter MultEQ [RETURN] Cancel NOTE If a connected speaker is not displayed, the speaker may not be connected correctly. Check the speaker connection. 9 Use ui to select "Next → Measure" and then press ENTER. vSee overleaf Information 17