NEC PX-42M3A PlasmaSync 4200W - Page 6
How to Attach Options to the Plasma Monitor
View all NEC PX-42M3A manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
How to Attach Options to the Plasma Monitor You can attach your option to the plasma monitor in one of the following two ways: * As it is made upright. (See Drawing A) * As it is laid down with the screen face down (See Draw- ing B). Lay the protective sheet, which was wrapped around the monitor when it was packaged, beneath the screen surface so as not to scratch the screen face. Drawing A • This device cannot be installed on its own. Be sure to use a stand or original mounting unit. (Wall mount unit, Stand, etc) * See page 2. • For correct installation and mounting it is strongly recommended to use a trained,authorized NEC dealer. Failure to follow correct mounting procedures could result in damage to the equipment or injury to the installer. Product warranty does not couer damage caused by improper installation. Drawing B Ventilation Requirements for Wall enclosure mounting To allow heat to disperse, leave space between surrounding objects as shown on the diagram be- 31mm (1.22") 31mm (1.22") low when installing. 1110mm (43.7") Wall 50mm (2") 748mm (29.5") 50mm (2") 1