Netgear GS418TPP Hardware Installation Guide - Page 6

ProSAFE 16-Port Gigabit Smart Managed Switch with PoE+ and 2 SFP Ports • Includes the following mounting hardware: - Attachment to a wall or a pole - Two rubber belts - Rackmount kit • Full compatibility with IEEE standards: - IEEE 802.3 Ethernet - IEEE 802.3u 100BASE-T - IEEE 802.3z Gigabit Ethernet 1000BASE-SX/LX - IEEE 802.3ab 1000BASE-T - IEEE 802.1Q VLAN tagging - IEEE 802.3x Full-duplex flow control - IEEE 802.3ad Link Aggregation (LAG with LACP) - IEEE 802.1AB LLDP - IEEE 802.1p Class of Service (QoS) - IEEE 802.1D Spanning Tree Protocol (STP) - IEEE 802.1s Multiple Spanning Tree Protocol (MSTP) - IEEE 802.1w Rapid Spanning Tree Protocol (RSTP) - IEEE 802.1x RADIUS Network Access Control - IEEE 802.3az Energy Efficient Ethernet (EEE) • AutoSensing and autonegotiating capabilities for all ports. • Auto Uplink™ technology is supported on all ports. • Automatic address learning function to build the packet-forwarding information table. The table contains up to 16K Media Access Control (MAC) addresses. • Store-and-forward transmission to remove bad packets from the network. • Full-duplex IEEE 802.3x pause frame flow control. • Active flow control to minimize packet loss and frame drops. • Half-duplex backpressure control. • Per-port status LEDs and system status LEDs. • NETGEAR green power-saving features: - Energy efficiency mode that fully conforms to the IEEE802.3az standard - Per-port automatic change to a lower power mode when the port link is down Introduction 6