Netgear GS716Tv2 GS716Tv2/GS724Tv3 Software Admin Manual - Page 232

GS716Tv2 and GS724Tv3 Software Administration Manual 3. From the MAC Binding Configuration screen, assign the Sales_ACL to the interface gigabit ports 6, 7, 8, 9, and 10, and then click Apply (See "MAC Binding Configuration" on page 5-44). Figure B-1 You can assign an optional sequence number to indicate the order of this access list relative to other access lists if any are already assigned to this interface and direction. 4. The MAC Binding Table displays the interface and MAC ACL binding information (See "MAC Binding Table" on page 5-45). The ACL named Sales_ACL looks for Ethernet frames with destination and source MAC addresses and MAC masks defined in the rule. Also, the frame must be tagged with VLAN ID 2, which is the Sales department VLAN. The CoS value of the frame must be 0, which is the default value for Ethernet frames. Frames that match this criteria are permitted on interfaces 6, 7, 8, 9, and 10 and are assigned to the hardware egress queue 0, which is the default queue. All other traffic is explicitly denied on these interfaces. To allow additional traffic to enter these ports, you must add a new permit rule with the desired match criteria and bind the rule to interfaces 6, 7, 8, 9, and 10. Standard IP ACL Example Configuration The following example shows how to create an IP-based ACL that prevents any IP traffic from the Finance department to be allowed on the ports that are associated with other departments. Traffic from the Finance department is identified by each packet's network IP address. B-6 Configuration Examples v1.0, July 2009