Netgear PTV1000 PTV1000 User Manual - Page 13

Push 2 TV Adapter (PTV1000)/Intel Wireless Display User Manual • ID. If the default name has not been changed, use the ID to distinguish multiple entries and find your adapter. • Model. This is the adapter manufacturer and product model name. • Signal. The number of bars represents signal strength. The scale ranges from one bar (weakest signal) to five bars (strongest signal). The bars turn from green to yellow if the signal strength falls below three bars. Step 6: Connecting to the TV To connect the laptop to the TV, click once on the adapter and then click the Connect button. (If there are multiple adapters detected, use the ID to find the adapter.) When connecting, the laptop and TV screens both read Connecting... If the laptop status reads Connecting... and the TV screen still reads Ready for Connection, click the Cancel connect button and try connecting again. If this does not work, the connection may be blocked by a firewall. For help allowing the application through a firewall, see "Firewall Issues" on page 2-6. For additional connection help, see "Common Solutions to Many Issues" on page 2-7. See "What is Auto-Connect" on page 2-13 for information about automatically connecting to an adapter after the first connection has been made. If this is the initial set up, you will not see Steps 7 and 8. Proceed to "First Time Connection Procedures" on page 1-5. Step 7: Connected to the Adapter After the laptop connects to the adapter, the TV reads Connected. Please wait. This message appears for only a few seconds. If the TV reads Connected. Please Wait for more than 1 minute, the connection attempt failed. Click the Disconnect button and try connecting again. Step 8: Ready to Use Intel Wireless Display After the Connected. Please Wait. message disappears, the laptop and TV screen are the same and your adapter is displayed in the Connected adapter field. You are now ready to enjoy and share your favorite pictures, videos, and music. If you want to move Intel Wireless Display out of the display area, use the minimize button instead of the close button. -4 v1.0, January 2010