Onkyo PR-SC5508 Owner Manual - Page 76
Connecting Zone 3, Setting the Multi Zone, Connecting Your Zone 3 Speakers - firmware
View all Onkyo PR-SC5508 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 76 highlights
Connecting Zone 3 Zone 3 speakers must be connected to an amp in Zone 3. Connecting Your Zone 3 Speakers You can enjoy 2-channel stereo playback in Zone 3 and a different source to those selected for your main room and Zone 2. Hookup • Use an RCA audio cable to connect the AV controller's PRE OUT ZONE 3 L/R jacks to an analog audio input on your Zone 3 amp. • Use an RCA audio cable to connect the AV controller's PRE OUT ZONE 3 SUBWOOFER jack to the line input on a powered subwoofer in Zone 3. • Connect your Zone 3 speakers to the speaker terminals on your Zone 3 amp. Main room Multichannel power amp AV controller Setting the Multi Zone 1 Press RECEIVER followed by SETUP. The main menu appears onscreen. Tip • If the main menu doesn't appear, make sure the appropri- ate external input is selected on your TV. 2 Use R/X to select "Hardware Setup", and then press ENTER. The "Hardware Setup" menu appears. 7. Hardware Setup 1. Remote ID 2. Multi Zone 3. Tuner 4. HDMI 5. Auto Power Down 6. Network 7. Firmware Update 3 Use R/X to select "Multi Zone", and then press ENTER. The "Multi Zone" menu appears. 7-2. Multi Zone Zone 2 Out Zone 2 Maximum Volume Zone 2 Power On Volume Zone 2 Component Out Zone 3 Out Zone 3 Maximum Volume Zone 3 Power On Volume Fixed Off Last Use Fixed Off Last 4 Use R/X to select an item, and use F/S to change it. The items are explained below. 5 Press SETUP. The setup menu closes. Zone 3 LINE INPUT Powered subwoofer IN R L Receiver/ integrated amp Note • With the default settings, the Zone 3 volume must be set on the Zone 3 amp. If your Zone 3 amp has no volume control, set the "Zone 3 Out" setting to "Variable" so that you can set the Zone 3 volume on the AV controller (➔ 76). Note • This procedure can also be performed on the AV controller by using SETUP, arrows, and ENTER. ■ Zone 2 Out, Zone 3 Out ` Fixed: The Zone 2/3 volume must be set on the amp in that zone. ` Variable: The Zone 2/3 volume can be set on the AV controller. If you've connected your Zone 2/3 speakers to an amp with no volume control, set the "Zone 2 Out" and "Zone 3 Out" setting, respectively, to "Variable" so that you can set the volume, balance, and tone of Zone 2/3 on the AV controller. ■ Zone 2 Maximum Volume, Zone 3 Maximum Volume ` Off, 50 to 99 (Absolute display) ` Off, -32dB to +17dB (Relative display) With this setting, you can limit the maximum volume for Zone 2/3. En 76