Onkyo PR-SC5508 Owner Manual - Page 77

■ Zone 2 Power On Volume, Zone 3 Power On Volume `Last, Min, 1 to 99 or Max (Absolute display) `Last, -2dB, -81dB to +18dB (Relative display) This setting determines what the volume will be for Zone 2/3 each time the AV controller is turned on. To use the same volume level as when the AV controller was last turned off, select "Last". The "Zone 2 Power On Volume" and "Zone 3 Power On Volume" cannot be set higher than the "Zone 2 Maximum Volume" and "Zone 3 Maximum Volume" setting. ■ Zone 2 Component Out ` Use: Select if a TV in Zone 2 is connected the COMPONENT VIDEO ZONE 2 OUT. `Not Use: Select if no TV in Zone 2 is connected the COMPONENT VIDEO ZONE 2 OUT. If you've connected the COMPONENT VIDEO ZONE 2 OUT to a TV in Zone 2, this setting is set to "Use". Note • If the "Zone 2 Component Out" setting is set to "Not Use", the same video signal as COMPONENT VIDEO MONITOR OUT is output from ZONE 2 OUT (component). Using Zone 2/3 This section explains how to turn Zone 2/3 on and off, how to select an input source for Zone 2/3, and how to adjust the volume for Zone 2/3. Controlling Zone 2/3 from the AV controller ZONE 3 indicator ZONE 2 indicator ZONE 3 Input selector buttons ZONE 2 OFF 1 To turn on Zone 2/3 and select an input source, press ZONE 2 or ZONE 3 followed by an input selector button within 8 seconds. Zone 2/3 turns on, the ZONE 2/3 indicator lights. Tip • The 12V TRIGGER OUT goes high (+12 V). To select AM or FM, press TUNER input selector and ZONE 2 or ZONE 3 repeatedly. (North American models) You can also select SIRIUS. To select the same source as that of the main room, press ZONE 2 or ZONE 3 twice. "Zone2 Selector: Source" or "Zone3 Selector: Source" appears on the display. 2 To turn off Zone 2/3, press ZONE 2 or ZONE 3. ZONE 2 or ZONE 3 indicator flashes. Press OFF. The zone is turned off, and the ZONE 2 or ZONE 3 indicator goes off. Note • When Zone 2/3 is turned off, the output from the 12V TRIGGER OUT goes low (0 volts). En 77