Panasonic AJ-HDX900 Dvcpro Hd Camera - Page 26
To record video signals of a few, seconds before starting recording, PRE-RECORDING function
UPC - 791871302781
View all Panasonic AJ-HDX900 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 26 highlights
Chapter 3 Recording and playback (continued) Transitions with the jump operation Recorded section D Section not recorded (B, C) Pause for replaying Pause for replaying O Time code regeneration No recorded section is available. O Rewinding for 5 seconds Pause for recording O Time code regeneration O Rewound for 2 seconds and then played back Pause for recording No recorded section is available. O Rewinding for 5 seconds Stopped Stopped Rec-review For details, refer to "3-7 To check the last few seconds of the recording (Rec-review function)". No recorded section is available. O Rewinding for 5 seconds If the recorded section is found O Rewound to the recorded part O Time code regeneration O Rewound for 2 seconds and then played back 3-4 To record video signals of a few seconds before starting recording (PRE-RECORDING function) By always storing a few seconds' worth (maximum of 7 seconds) of audio and video data shot by the camera, it is possible to record video and audio signals a few seconds before recording is actually started by pressing the REC START button or the VTR button on the lens in the built-in memory. In order for this function to be used, it is necessary to open the screen from the SYSTEM SETTING page and set the data storage time in memory using the PRE REC MODE item and the PRE REC TIME item using the menu operation. PRE REC MODE ON: PRE RECORDING function is activated. OFF: Recording starts about 0.4 seconds after pressing the REC START button or the VTR button on the lens. If you stop recording by pressing the REC START button or the VTR button on the lens, the message "TAPE ¢S" will be displayed on the viewfinder screen. PRE REC TIME From 0 to 7 seconds: A value from 0 to 7 seconds is set as the length of time for which the video and audio signals can be recorded before the REC START button or the VTR button on the lens is pressed. ≥ If the PRE REC MODE items is set to "OFF", recording starts about 0.4 seconds after pressing the REC START button when the VTR SAVE/STBY switch is set to either SAVE or STBY position. If the PRE REC MODE item is set to "ON," video signals for the time set in the PRE REC TIME item before starting are recorded. ≥ The data contained in the storage memory becomes unstable immediately after the power is turned on, immediately after the PRE REC MODE item setting is selected or its set time has been changed, and immediately after playback or rec-review has been performed. Immediately after any of these operations, therefore, the video and audio signals will not be prerecorded for the duration set when recording is started by pressing the REC START button or VTR button on the lens. ≥ The video data and audio data are not stored in the storage memory while playback or rec-review is being performed. This means that the pre-recording will not include the video and audio signals supplied during a playback or rec-review operation. ≥ When recording has been started, the time code (TCG) display may remain in the hold status until it is possible for the time code (TCR) on the tape to be read. REC start (recording start) REC pause Real-time video signals Real-time audio signals A B C PRE-REC time set What is recorded on the tape Previous cut A B 26