Panasonic DMREZ47V Dvd Recorder - English/spanish - Page 90

Error Messages On the Unit's Display Page H ,F (" " stands for a service number.) An error has occurred. The number following "H" or "F" depends − on the status of the unit. Check the items below and in the Troubleshooting Guide. If the service number still does not disappear after the check, reset the unit (¼ 78, "To restore the unit if it freezes"). If the service numbers fail to clear, note the service numbers and − contact a qualified service person. RC (" " stands for a number.) The remote control and the main unit are using different codes. 78 Change the code on the remote control. HARD ERR If there is no change after turning the unit on and off, consult the − ("HArd" and "Err" are alternately dealer where the unit was purchased. displayed.) NO READ The disc is dirty or badly scratched. The unit cannot record, play, or edit. 73 ("NO" and "REAd" are alternately displayed.) The disc may be incompatible or of poor quality. 74 to 76 You have used a lens cleaner and it has finished operation. Press 72 [ OPEN/CLOSE] on the main unit to eject the disc. Displayed when the unit is started. This is not a malfunction. − The unit is carrying out its recovery process. You cannot operate the − unit while " " is displayed. FULL There are already 16 scheduled recording programs. Delete 18 unnecessary scheduled recording programs. UNSUPPORT ("UNSUP" and "POrt" are alternately displayed.) You have inserted a disc the unit cannot play or record on. 74, 75 UNFORMAT ("UNFOr" and "MAt" are alternately displayed.) You have inserted a new DVD-RW/+RW or a DVD-RAM/DVD-RW 15, 45 (DVD-Video format) recorded on other equipment. You can format the disc when the format confirmation screen is displayed. " " is displayed on the This unit is confirming that it is connected with equipment − unit's display. compatible with HDAVI Control. F74 The HDMI connection could not be authenticated due to a transfer − malfunction. Consult the dealer where the unit was purchased. F75 The HDMI connection could not be authenticated due to an internal − data malfunction. Consult the dealer where the unit was purchased. U59 The unit is very warm. − The unit switches to standby for safety reasons. Wait for about 30 minutes until the message disappears. Reinstall the unit in an area with adequate ventilation. Do not block the cooling fan on the rear of the unit. U61 There was a power failure or the AC power supply cord was − disconnected while the unit was on. The unit is carrying out its recovery process. This process restores the unit to normal operation. The unit is not broken. Wait until the message disappears. U72 The HDMI connection acts unusually. − U73 -The connected equipment is not HDMI compatible. -The HDMI cable is too long. Please use a cable 5.0 meters (16.4 ft.) or less. -The HDMI cable is damaged. U76 HDMI cannot be output because you are connected to a model that − does not support copyright protection. U88 There was something unusual detected with the disc while recording, 80 playing or copying; there was a power failure or the AC power supply cord was disconnected while the unit was on. The unit is carrying out its recovery process. This process restores the unit to normal operation. The unit is not broken. Wait until the message disappears. U99 The unit fails to operate properly. Press [/I POWER] on the main − unit to switch the unit to standby. Press [/I POWER] on the main unit again to turn the unit on. 90 RQT8853