Panasonic KX-MB262CX Operating Instructions - Page 19
Document Requirements, 2.4 Setting the original, Preparation
View all Panasonic KX-MB262CX manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 19 highlights
Document Requirements 2.4 Setting the original 2.4.1 Using the scanner glass 1 2. Preparation 2.4.2 Using the auto document feeder (KXMB772 only) 1 2 1 Open the document cover (1). 2 Place the document FACE DOWN on the scanner glass (2), aligning the top left of the document with the corner to which the m mark points. 3 Close the document cover. Note: L Confirm that there are no documents in the auto document feeder (KX-MB772 only). L Place the original onto the scanner glass gently and do not press down too firmly to avoid malfunction. L If the original is a thick book, do not close the document cover. L Check that ink, paste or correction fluid has dried completely. L Effective scanning area is as follows: Effective scanning area L Shaded area will be scanned. 4 mm 208 mm 5 mm 287 mm 4 mm 5 mm 1 Insert the document (up to 20 pages) FACE UP into the feeder until a single beep is heard. 2 Adjust the width of the document guides (1) to fit the actual size of the document. Note: L Confirm that there are no documents on the scanner glass. L Check that ink, paste or correction fluid has dried completely. L Remove clips, staples or other fasteners. L Do not set the following types of documents: (Make a copy of the document using the scanner glass and set the copy instead.) - Chemically treated paper such as carbon or carbonless duplicating paper - Electrostatically charged paper - Badly curled, creased or torn paper - Paper with a coated surface - Paper with printing on the opposite side that can be seen through the other side, such as newsprint L The total height of the documents when laid flat, must be less than 4 mm. If the documents exceed the capacity of the auto document feeder, they may fall or cause a jam in the feeder (KX-MB772 only). L To set a document with a width of less than 210 mm, we recommend using the scanner glass to copy the original document onto A4 or letter-sized paper, then setting the copied document (KX-MB772 only). L Do not set documents that do not satisfy the requirements of size and weight. Make a copy of the document using the scanner glass and set the copy (KX-MB772 only). L Available document size, document weight and effective scanning area are as follows: 19