Pioneer AVIC-X920BT Owner's Manual - Page 191
Appendix
UPC - 884938104241
View all Pioneer AVIC-X920BT manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 191 highlights
Appendix Appendix Appendix Symptom Cause Action (Reference) You cannot position your vehicle Something covers the GPS antenna. Do not cover the GPS antenna with spray on the map without a significant paint or vehicle wax, because this may block positioning error. the reception of GPS signals. Snow buildup can also degrade the signals. Signals from the vehicle's speed Check that the cables are properly connected. pulse are not being picked up prop- If necessary, consult the dealer that installed erly. the system. The navigation system may not be mounted securely in your vehicle. Check that the navigation system is securely mounted and, if necessary, consult the dealer that installed the system. The navigation system is installed with an extreme angle exceeding the installation angle limitations. Confirm the installation angle. (The navigation system must be installed within the allowed installation angle. For details, refer to Installation Manual.) Indication of the position of your vehicle is misaligned after a U-turn or reversing. Check whether or not the reverse gear signal input lead (violet) is connected properly. (The navigation system works properly without the lead connected, but positioning accuracy will be adversely affected.) "Eco Graph" is not available. The navigation system is unable to obtain past average fuel mileage data, so "Eco Graph" cannot be displayed. Drive about 6 miles (10 km) on a road without obstructions. Then park your vehicle in a safe place, turn off the navigation system and turn the power to the navigation system back on. The map color does not switch "Day/Night Display" is set to automatically between daytime "Day". and nighttime. Check "Day/Night Display" setting and make sure "Automatic" is selected. (Page 159) The orange/white lead is not connected. Check the connection. The screen is too bright. Picture quality adjustment of the display is not correct. Adjust the picture quality. (Page 167) The display is very dim. The vehicle's light is turned ON, and Read about "Day/Night Display" setting "Automatic" is selected on "Day/ and, if desired, select "Day". (Page 159) Night Display". Picture quality adjustment of the display is not correct. Adjust the picture quality. (Page 167) No sounds of AV source are pro- The volume level is low. duced. The volume level will not rise. The attenuator or mute is on. A speaker lead is disconnected. Adjust the volume level. Turn the attenuator or mute off. Check the connection. The volume of navigation gui- VOL (+/-) button is used to adjust dance and beeps cannot be ad- the volume. justed. Turn the volume up or down using [Volume] on the "System Settings" menu. (Page 163) The person on the other end of the phone call cannot hear the conversation due to an echo. The voice from the person on the Use the following methods to reduce the other end of the phone call is output echo: from the speakers and then picked -Lower the volume on the receiver up by the microphone again, creat- -Have both parties pause slightly before ing an echo. speaking En 191