Pioneer HTZ-BD32 Owner's Manual - Page 75
Adjusting the video, Adjust speaker settings, Adjust speaker settings while listening, to a sound, - change default input setting
View all Pioneer HTZ-BD32 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 75 highlights
Advanced settings 75 En Adjusting the video Setting the IP address 1. Select and set Display Setting d Video Adjust d Next Screen. Use / to select, then press ENTER. 2. Select the item and change the setting. Use / to select the item, then use / to change the setting. Once the setting is completed, press RETURN to close the settings screen. Item Brightness Contrast Hue Saturation Description Select this to adjust the TV screen's brightness. Select this to adjust the TV screen's contrast. Select this to adjust the color (green and red) balance of the TV screen. Select this to adjust the TV screen's saturation. 1. Select and set Network d IP Setting d Next Screen. Use / to select, then press ENTER. 2. Set IP address. Use / / / to set the IP address of the player or DNS server, then press ENTER. yy Auto Set IP Address On - The player's IP address is obtained automatically. Select this when using a broadband router or broadband modem that has a DHCP (Dynamic Host Configuration Protocol) server function. This player's IP address will automatically be allocated from the DHCP server. Off - The player's IP address must be set manually. Use the number buttons (0 to 9) to input the IP address, subnet mask and default gateway. Adjust speaker settings 1. Select and set Audio Output d Speaker Setup d Next Screen. Use / / / to select, then press ENTER. 2. A picture of speakers will be shown on the screen. Select the speaker using cursor and press ENTER. 3. Use / to select Trim or Delay and then press ENTER. 4. Use cursor / to adjust the setting, then press ENTER. Note yy For information on the DHCP server function, refer to the operating instructions for the network device. yy You may need to contact your Internet service provider or network administrator when inputting the IP address manually. Advanced settings Adjust speaker settings while listening to a sound 1. Select and set Audio Output d Test Tone d Next Screen. Use / / / to select, then press ENTER. 8 2. A test tone will be output. The speakers will switch automatically. 3. A picture of speakers will be shown on the screen. Press ENTER when the speaker you wish to adjust to is focused. 4. Use / to select Trim or Delay and then press ENTER. 5 Use / to adjust the setting, then press ENTER. *1ms = 30 cm