Ryobi RMX001 Operation Manual - Page 14

OPERATION DANGER: Risk of explosion. Do not use this tool to mix flammable or explosive materials. Fire or explosion can cause severe burns or death. WARNING: Do not allow familiarity with products to make you careless. Remember that a careless fraction of a second is sufficient to inflict severe injury. WARNING: Always wear eye protection with side shields marked to comply with ANSI Z87.1 when operating this equipment. Failure to do so could result in objects being thrown into your eyes, resulting in possible serious injury. WARNING: Do not use any attachments or accessories not recommended by the manufacturer of this product. The use of attachments or accessories not recommended can result in serious personal injury. WARNING: Use safety equipment. Protect your eyes, skin, and lungs while filling, mixing, and emptying the mixer. Failure to do so may cause serious personal injury. WARNING: Do not reach into the drum with your hands or insert any other objects including trowels and shovels into it while mixing. Contact with the tines or substances inside the drum may lead to serious personal injury. TURNING THE MIXER ON AND OFF See Figure 14. The on/off switch on the back of the motor assembly is used to turn the mixer on and off. When the mixer is turned on, the drum will spin. When the mixer is turned off, the drum will stop. OVERLOAD PROTECTION See Figure 14. When the mixer is overloaded or the motor is overheated for any reason, the circuit breaker will trip and the mixer will automatically shut off. Before resuming operation, allow the motor to cool. After the motor is cool, press the circuit breaker reset button and turn the motor on to continue mixing. If the mixer still does not resume operation, unplug the tool and empty some or all of the batch load. Do not force the mixer. NOTICE: Routinely make a visual inspection of the mixer and the material being mixed. Do not let materials dry and harden inside the drum or on any part of the product. Failure to follow this warning could result in property damage or malfunction of the product. NOTICE: Use caution when working with fast hardening material such as quick set concrete. A few minutes of inactivity may be sufficient to allow the material to set. Setting times vary; refer to the material manufacturer's instructions. CIRCUIT BREAKER RESET BUTTON NOTICE: Before each use, inspect the entire product for damaged, missing, or loose parts such as screws, nuts, bolts, caps, etc. Tighten securely all fasteners and caps and do not operate this product until all missing or damaged parts are replaced. Please contact customer service or a qualified service center for assistance. APPLICATIONS You may use this tool for the purposes listed below:  Mixing stucco, cement, mortar, aggregates (i.e. sand, gravel, etc.) and other materials. ON/OFF BUTTON Fig. 14 14 − English