Samsung SC-DC564 User Manual (user Manual) (ver.1.0) (English, French) - Page 122
Symptom, Explanation/Solution, Start/Stop], Check the Battery Pack or the AC Power
UPC - 036725301542
View all Samsung SC-DC564 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 122 highlights
Troubleshooting Dépannage If these instructions do not solve your problem, contact your nearest Samsung authorized service center. Si ces directives ne solutionnent pas votre problème, contactez votre Centre de services Samsung le plus près. Symptom Explanation/Solution You cannot switch the Check the Battery Pack or the AC Power DVD Camcorder on. adapter. The DVD Camcorder shuts off automatically. You have left the DVD Camcorder set to STBY for more than 5 minutes without using it. To turn on the DVD Camcorder, press the [Start/Stop] button. The Battery Pack is fully exhausted. Replace it with a fully charged battery pack. Charge runs out quickly. The atmospheric temperature is too low. The Battery Pack has not been charged fully. The Battery Pack is completely dead, and cannot be recharged, use another Battery Pack. A vertical strip appears on the screen when recording a dark background. The contrast between the subject and the background is too great for the DVD Camcorder to operate normally. Make the background bright to reduce the contrast or use the BLC function while you are recording in bright Surroundings. The Viewfinder lens has not been adjusted. The image in the Adjust the Viewfinder control lever until Viewfinder is blurred. the indicators displayed on the Viewfinder come into sharp focus. Auto focus does not work. Check the Manual Focus menu. Auto focus does not work in the Manual Focus mode. When the power is turned off and then turned on, a blue screen appears instead of the normal screen. If the DC Adapter is connected, remove the cord, turn on the Power switch, and then connect it again. If the battery is connected, disconnect it, turn the Power switch to on, and then connect it again. Symptôme Explication/Solution Vous ne pouvez pas allumer le DVD caméscope. Vérifiez le bloc-piles ou l'adaptateur CA. Le DVD caméscope s'éteint automatiquement. Vous avez laissé le DVD caméscope réglé sur STBY pendant plus de 5 minutes sans l'utiliser. Appuyez sur la touche [Start/Stop] pour mettre le DVD caméscope sous tension. Le bloc-piles est à plat. Remplacer par un bloc-piles à pleine charge. La charge se dépense rapidement. La température atmosphérique est trop basse. Le bloc-piles n'est pas suffisamment chargé. Le bloc-piles est complètement à plat et ne peut être rechargé ; utilisez un autre bloc-piles. Le contraste entre le sujet et l'arrière- plan est trop important pour que le Une bande verticale DVD caméscope puisse fonctionner apparaît à l'écran si normalement. Illuminez l'arrière-plan pour vous enregistrez un réduire le contraste ou utilisez la fonction arrière plan sombre. BLC (Compensation du contre-jour) si vous enregistrez dans un environnement fortement illuminé. L'image du viseur est floue. L'objectif du viseur est mal réglé. Ajustez le contrôle du viseur jusqu'à ce que les témoins affichés sur le viseur soient nets. La mise au point automatique ne fonctionne pas. Vérifiez le menu de la mise au point manuelle. La mise au point automatique ne fonctionne pas en mode de mise au point manuelle. Lorsque mis hors tension et ensuite sous tension, un écran bleu s'affiche plutôt Si l'adaptateur CA est branché, enlevez le cordon électrique, mettez le sous tension et rebranchez. Si le bloc-piles est inséré, retirez-