Sharp DT 400 DT-400 Operation Manual - Page 25
Connecting to a Computer - service manual
![]() |
UPC - 074000364332
View all Sharp DT 400 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 25 highlights
Connecting to a Computer When connecting a computer, ensure that it is the last device to be turned on after all the connections are made. Connecting to a computer (INPUT 5) • Before connecting the cable, switch the digital input type switch to "PC". Computer INPUT 5 terminal 1 Switch to "PC" RGB output terminal 2 RGB cable (commercially available) 4 3 DVI to 15-pin D-sub adaptor (sold separately: AN-A1DV) Note • Refer to "Computer Compatibility Chart" on page 60 for a list of computer signals compatible with the projector. Use with computer signals other than those listed may cause some of the functions not to work. • When connecting the projector to a computer in this way, select "RGB" for "Signal Type" on the OSD menu or press on the remote control. (See page 48.) • A Macintosh adaptor may be required for use with some Macintosh computers. Contact your nearest Sharp Authorized Service Center or Dealer. • Depending on the computer you are using, an image may not be projected unless the signal output setting of the computer is switched to the external output. Refer to the computer operation manual for switching the computer signal output settings. Connections -25
![](/manual_guide/products/sharp-dt-400-dt400-operation-manual-63c4da1/25.png)