Sharp DT 400 DT-400 Operation Manual - Page 27

Turning the Projector On/Off Connecting the Power Cord Plug the supplied power cord into the AC socket. Supplied accessory Power cord (6' (1.8 m)) Turning the Projector On Before performing the steps in this section, connect any equipment that you use with the projector. (See pages 19-26.) Remove the lens cap and press on the projector or on the remote control. • The power indicator illuminates green. • After the lamp indicator illuminates, the projec- tor is ready to start operation. Note • The lamp indicator illuminates or blinks, in- dicating the status of the lamp. Green:The lamp is ready. Blinking green: The lamp is warming up or shutting down. Red: The lamp is shut down abnormally or the lamp should be replaced. • When switching on the projector, a slight flickering of the image may be experienced within the first minute after the lamp has been illuminated. This is normal operation as the lamp's control circuitry is stabilising the lamp output characteristics. This does not indicate malfunction. • If the projector is put into standby mode and immediately turned on again, the lamp may take some time to illuminate. Info • English is the factory preset language. If you want to change the on-screen display to another language, change the language according to the procedure on page 52. STANDBY button ON button Power indicator Lamp indicator ON button STANDBY button Lens cap Basic Operation -27