Sharp DT 400 DT-400 Operation Manual - Page 7
Ensure that you read the following safeguards when, setting up your projector. - replacement lamps
UPC - 074000364332
View all Sharp DT 400 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
Introduction Ensure that you read the following safeguards when setting up your projector. Caution concerning the lamp unit ■ Potential hazard of glass particles if lamp ruptures. In case of lamp rupture, contact your nearest Sharp Authorized Service Center or Dealer for a replacement. See "Replacing the Lamp" on page 56. Caution concerning the setup of the projector ■ For minimal servicing and to maintain high image quality, SHARP recommends that this projector be installed in an area free from humidity, dust and cigarette smoke. When the projector is subjected to these environments, the vents and lens must be cleaned more often. As long as the projector is regularly cleaned, use in these environments will not reduce the overall operation life of the unit. Internal cleaning should only be performed by a Sharp Authorized Service Center or Dealer. Do not set up the projector in places exposed to direct sunlight or bright light. ■ Position the screen so that it is not in direct sunlight or room light. Light falling directly on the screen washes out the colors, making viewing difficult. Close the curtains and dim the lights when setting up the screen in a sunny or bright room. The projector may be safely tilted to a maximum angle of 12 degrees. ■ Placement should be within ±12 degrees of horizontal. Warning about placing the projector in a high position ■ When placing the projector in a high posi- tion, ensure to secure it carefully to avoid personal injury caused by the projector falling down. Do not subject the projector to hard impact and/or vibration. ■ Take care with the lens so as not to hit or damage the surface of the lens. Rest your eyes occasionally. ■ Continuously watching the screen for long hours will cause eye strain. Ensure to occasionally rest your eyes. Avoid locations with extremes of temperature. ■ The operating temperature of the projector is from 41°F to 95°F (+5°C to +35°C). ■ The storage temperature of the projector is from -4°F to 140°F (-20°C to +60°C). Do not block the exhaust and intake vents. ■ Allow at least 7 7/8 inches (20 cm) of space between the exhaust vent and the nearest wall or obstruction. ■ Ensure that the intake vent and the exhaust vent are not obstructed. ■ If the cooling fan becomes obstructed, a protection circuit will automatically put the projector into standby mode to prevent overheat damage. This does not indicate a malfunction (See pages 54 and 55.). Remove the projector power cord from the wall outlet and wait at least 10 minutes. Place the projector where the intake and exhaust vents are not blocked, plug the power cord back in and turn on the projector. This will return the projector to the normal operating condition. -7