Sharp PG-LS2000 PG-LX2000 PG-LS2000 Operation Manual - Page 54
Using 3D Viewing Mode, Projecting 3D images, Ending 3D projection
View all Sharp PG-LS2000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 54 highlights
Viewing Stereoscopic 3D Images (Continued) Using 3D Viewing Mode Use the following procedure to project 3D images. For operation of the 3D LCD shutter glasses and the 3D-video playback equipment, see the corresponding operation manual. ENTER button O/Qbuttons 6 Press 3D MODE on the remote control to display the 3D MODE menu. Info • If "An invalid button has been pressed." is displayed, a 3D-compatible signal is not being input. Check the output signal on the playback equipment. 7 Press Q to set "DLP® Link™" to "On". 8 Press ENTER to switch the mode and enable more natural 3D image viewing. 3D MODE button Projecting 3D images Warning! • If the projector, 3D-video playback equipment, and 3D LCD shutter glasses are not properly set, you may experience eye strain in addition to not being able to view the images in 3D. 1 Turn the projector on. 2 Turn the 3D-video playback equipment on. • Set the 3D-video playback equipment so that it outputs one of the signals listed in the Compatibility Chart in this operation manual. 3 Switch the Input mode of the projector to enable input of 3D video signals. 9 Press 3D MODE. • The 3D MODE menu will disappear. Note • If the images are not displayed in 3D, repeat steps 6 to 8. • You can also use "DLP® Link™" and "DLP® Link™ Invert" on the menu screen to change the 3D setting. Ending 3D projection 4 Operate the 3D-video playback equipment and play back the 3D content. 1 Press 3D MODE on the remote control to display the 3D MODE menu. 5 Turn the 3D LCD shutter glasses on and place them over your eyes. 2 Press O to set "DLP® Link™" to "Off". 3 Press 3D MODE. • The 3D MODE menu will disappear. 52