Sharp PG-LS2000 PG-LX2000 PG-LS2000 Operation Manual - Page 69
Problem, Check, See Maintenance Indicators.
View all Sharp PG-LS2000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 69 highlights
Problem Check Maintenance indicator on • See "Maintenance Indicators". the projector illuminates or blinks in red. Picture is green on COMPUTER (YPbPr)/ HDMI (YPbPr) • Change the input signal type setting. Picture is pink (no green) on COMPUTER (RGB)/ HDMI (RGB) Picture is too bright and • Image adjustments are incorrectly set. whitish. The cooling fan becomes • When temperature inside the projector increases, the cooling fan runs noisy. faster. The lamp does not light • The lamp indicator is illuminating in red. up even after the Replace the lamp. projector turns on. The lamp suddenly turns off during projection. The image sometimes • Cables are incorrectly connected to the projector or the connected flickers. equipment works improperly. • If this happens frequently, replace the lamp. The lamp needs much • The lamp will eventually need to be changed. time to turn on. While the remaining lamp life draws to a close, replace the lamp. Picture is dark. The remote control cannot be used. • Operate the remote control while pointing it at the projector's remote control sensor. • The remote control may be too far away from the projector. • If direct sunlight or a strong fluorescent lamp is shining on the projector's remote control sensor, place the projector where it will not be affected by strong light. • The batteries may be depleted or inserted incorrectly. Make sure the batteries are inserted correctly or insert new ones. Page 54 41 39 8, 9 53, 54, 55 54, 57, 58 19 -2 2 57 57 13 13 Appendix 67