Sony DCR-HC26 Operating Guide - Page 13
To use an outside power source, To remove the battery pack, When storing the battery pack - connect to computer
UPC - 027242688711
View all Sony DCR-HC26 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
Getting Started 5 The CHG (charge) lamp turns off when the battery is fully charged. Disconnect the AC Adaptor from the DC IN jack. Disconnect the AC Adaptor from the DC IN jack holding both the camcorder and the DC plug. To use an outside power source You can operate your camcorder using the power from the wall outlet by making the same connections as you do when charging the battery pack. The battery pack will not lose its charge in this case. To remove the battery pack 1 Slide the POWER switch to OFF(CHG). Hold down the V BATT(battery) release lever with one hand. 2 Remove the battery in the direction of the arrow with the other hand. POWER switch 1 2 V BATT (battery) release lever When storing the battery pack Fully discharge the battery before storing it for an extended period (p. 81). Charging time Approximate time (min.) required when you fully charge a fully discharged battery pack. Battery pack Charging time NP-FP30 (supplied) 115 NP-FP50 125 NP-FP70 155 NP-FP71 170 NP-FP90 220 Recording time Approximate time (min.) available when you use a fully charged battery pack. Battery pack Continuous recording time Typical recording time* NP-FP30 (supplied) 95 45 110 55 NP-FP50 135 65 160 80 NP-FP70 280 140 330 165 NP-FP71 330 165 395 195 NP-FP90 500 250 580 290 • All times measured under the following conditions: Top: Recording with LCD screen. Bottom: Recording with viewfinder while the LCD panel closed. * Typical recording time shows the time when you repeat recording start/stop, turning the power on/off and zooming. Continued , 13