Sony DCR-HC26 Operating Guide - Page 85

LCD screen • Do not exert excessive pressure on the LCD screen, as it may cause damage. • If your camcorder is used in a cold place, a residual image may appear on the LCD screen. This is not a malfunction. • While using your camcorder, the back of the LCD screen may heat up. This is not a malfunction. x To clean the LCD screen If fingerprints or dust make the LCD screen dirty, it is recommended you use a soft cloth to clean it. When you use the LCD Cleaning Kit (optional), do not apply the cleaning liquid directly to the LCD screen. Use cleaning paper moistened with the liquid. x On adjustment of the LCD screen (CALIBRATION) The buttons on the touch panel may not work correctly. If this happens, follow the procedure below. It is recommended you connect your camcorder to the wall outlet using the supplied AC Adaptor during the operation. 1 Slide the POWER switch to OFF(CHG). 2 Eject the cassette from your camcorder, then disconnect any connecting cables except the AC Adaptor from your camcorder. 3 Slide the POWER switch repeatedly to turn on the PLAY/EDIT lamp while pressing DISP/BATT INFO on your camcorder, and keep pressing down DISP/BATT INFO for about 5 seconds. 4 Touch the "×" displayed on the screen with the corner of the "Memory Stick" or the like. The position of the "×" changes. If you did not press the right spot, start from step 4 again. • You cannot calibrate the LCD screen if it is rotated. On handling the casing • If the casing is soiled, clean the camcorder body with a soft cloth lightly moistened with water, and then wipe the casing with a dry soft cloth. • Avoid the following to avoid damage to the finish. - Using chemicals such as thinner, benzine, alcohol, chemical cloths, repellent, insecticide and sunscreen. - Handling with above substances on your hands. - Leaving the casing in contact with rubber or vinyl objects for a long period of time. About care and storage of the lens • Wipe the surface of the lens clean with a soft cloth in the following instances: - When there are fingerprints on the lens surface. - In hot or humid locations - When the lens is exposed to salty air such as at the seaside. • Store in a well-ventilated location subject to little dirt or dust. • To prevent mold, periodically clean the lens as described above. It is recommended that you operate your camcorder about once a month to keep it in optimum state for a long time. On charging the pre-installed rechargeable battery Your camcorder has a pre-installed rechargeable battery to retain the date, time, and other settings even when the POWER switch is set to OFF(CHG). The preinstalled rechargeable battery is always charged while your camcorder is connected to the wall outlet via the AC Adaptor or while the battery pack is attached. The rechargeable battery will be fully discharged in about 3 months if you do not use your camcorder at all without the Continued , 85 Additional Information