Sony HTIS100 Operating Instructions - Page 25

Getting Started Before performing the Auto Calibration Before you perform the Auto Calibration, set up and connect the speakers (page 15). • The ECM-AC2 jack is used for the calibration mic (supplied) only. Do not connect other microphones to this jack. Doing so may damage the subwoofer and the calibration mic. • During the calibration, the sound that comes out of the speakers is very loud. Pay attention to the presence of children or to the effect on your neighborhood. • Perform the Auto Calibration in a quiet environment to avoid the effect of noise and to get a more accurate measurement. • If there are any obstacles in the path between the calibration mic and the speakers, the calibration cannot be performed correctly. Remove any obstacles from the measurement area to avoid measurement error. Notes • If the muting function is on when you perform the Auto Calibration, it will turn off automatically. • When you use the S-AIR product, disconnect the headphones. Bottom of the subwoofer BD IN DVD IN IR REMOTE SAT IN ANTENNA FM TV OUT HDMI AM VIDEO VIDEO IN DVD IN SAT IN MONITOR OUT Y IR IN IR OUT1 IR OUT2 DMPORT ECM-AC2 IR-R100 DC 5V 0.7A MAX 75 COAXIAL OPTICAL ASSIGNABLE L COAXIAL R EZW-T100 TV IN DVD IN SAT IN DIGITAL SPEAKER SAT IN AUDIO IN ASSIGNABLE ONLY FOR SS-IS15 PB/ CB PR/ CR COMPONENT VIDEO CENTER FRONT R FRONT L SUR R SUR L To ECM-AC2 jack Calibration mic 1 Connect the calibration mic (supplied) to the ECM-AC2 jack on the subwoofer. 2 Set up the calibration mic. Place the calibration mic at your listening position. You can also use a stool or tripod so that the calibration mic remains at the same height as your ears. Tip • The front of each speaker should face the calibration mic. You will get a more accurate measurement. continued 25US