Sony NEX-VG30H "Handycam" Handbook - Page 87

Table of Contents Additional information Troubleshooting If you run into any problems using your camcorder, follow the steps below.  Check the list (p. 87 to 95), and inspect your camcorder.  Disconnect the power source, attach the power source again after about 1 minute, and turn the camcorder on.  Press RESET (p. 110) using a pointed object, and turn the camcorder on. If you press RESET, all settings, including the clock setting, are reset.  Contact your Sony dealer or local authorized Sony service facility. socket). Connect it to the wall outlet (wall socket) (p. 15). The camcorder does not operate even when the power is set to on.  It takes a few seconds for your camcorder to be ready to shoot after the power is turned on. This is not a malfunction.  Disconnect the AC Adaptor from the wall outlet (wall socket) or remove the battery pack, then reconnect it after about 1 minute. If the functions still do not work, press RESET (p. 110) using a pointed object. (If you press RESET, all settings, including the clock setting, are reset.)  The temperature of your camcorder is extremely high. Turn off your camcorder and leave it for a while in a cool place.  The temperature of your camcorder is extremely low. Leave your camcorder with the power of your camcorder on. Turn off your camcorder and take it to a warm place. Leave the camcorder there for a while, then turn on your camcorder. Search image  Overall operations/Wireless Remote Commander p. 87  Batteries/power sources p. 88  LCD screen/viewfinder p. 88  Memory card p. 89  Recording p. 89  Playback p. 91  Playing back images stored on memory card on other devices p. 91  Editing movies/photos on your camcorder. p. 91  Playback on the TV p. 92  Copying/Connecting to other devices.......... p. 92  Connecting to a computer p. 92 Overall operations/Wireless Remote Commander The power does not turn on.  Attach a charged battery pack to the camcorder (p. 15).  The plug of the AC Adaptor has been disconnected from the wall outlet (wall Your camcorder gets warm.  Your camcorder may become warm during operation. This is not a malfunction. The supplied Wireless Remote Commander does not function.  Set [Remote Ctrl] to [On] (p. 85).  Insert a battery into the battery holder with the +/- polarities correctly matching the +/- marks (p. 112).  Remove any obstructions between the Wireless Remote Commander and the remote sensor.  The Wireless Remote Commander will also not work if the remote sensor (p. 111) is obstructed by the lens.  Point the remote sensor away from strong light sources such as direct sunlight or overhead lighting. Otherwise, the Wireless Remote Commander may not function properly. US 87 Index