Sony RDR-GX310 Operating Instructions - Page 89
Others, OPEN/CLOSE.
View all Sony RDR-GX310 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 89 highlights
Others The recorder does not operate properly. , Restart the recorder. Press down [/1 on the recorder for more than ten seconds until "WELCOME" appears in the front panel display. , When static electricity, etc., causes the recorder to operate abnormally, turn off the recorder and wait until the clock appears in the front panel display. Then, unplug the recorder and after leaving it off for a while, plug it in again. Five numbers or letters are displayed in the front panel display. , The self-diagnosis function was activated (see the table on page 90). The disc tray does not open after you press Z OPEN/CLOSE. , It may take a few seconds for the disc tray to open after you have recorded or edited a DVD. This is because the recorder is adding disc data to the disc. The disc tray does not open and "TRAY LOCKED" appears in the front panel display. , Contact your Sony dealer or local authorized Sony service facility. "FAN ERROR" appears in the front panel display. , Check that the vent on the rear of the recorder is not blocked. Then, immediately disconnect the AC power cord. Leave the recorder off for a while, then re-connect the power cord, and press [/1 on the recorder. The disc tray does not open and you cannot remove the disc after you press Z OPEN/ CLOSE. , Turn off the recorder. Once the clock appears in the front panel display, disconnect the power cord. (If the recorder does not turn off or if the clock does not appear in the front panel display, disconnect the power cord anyway.) Connect the power cord again while pressing down A on the recorder, and release the button when the disc tray opens. Then, keep [/1 on the recorder pressed for about ten seconds until "WELCOME" appears in the front panel display. "LOCKED" appears in the front panel display. , The disc tray is locked. Cancel the Child Lock (page 52). "RECOVERY" appears in the front panel display. , The recorder's recovery function was activated when the recorder was turned on because the power was turned off or failed during recording. Leave the recorder on until "RECOVERY" disappears from the front panel display. Additional Information 89