Sony STR-DA90ESG Operating Instructions - Page 18
Components
View all Sony STR-DA90ESG manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 18 highlights
Setting Up the Remote for On-Screen Control 18 7 When "PUSH YOUR REMOTE" appears in the on-screen display, press the button on the TV's remote that corresponds to the highlighted control button (e.g., POWER). • If your TV's remote has an independent input selector button (e.g., VIDEO 1). Register the IR code of this button when the VIDEO 1 button appears. When you turn on the receiver, the TV switches to the video input automatically. • If your TV does not have an independent input selector button or has a cyclic input selector button. Do not register an IR code of the input selector button. The TV's input cannot be switched automatically when you turn on the receiver. Switch the TV to the video input manually. If you registered an IR code for the VIDEO 1 button, erase the VIDEO 1 code following the steps in "To erase a specific IR code" below. • If you selected WIDE in step 4. Register the IR code for the wide TV mode button on your TV's remote when the WIDE TV DISPLAY MODE button appears. TV IR SET TV IR SET PUSH U RETURN I YOUR REMOTE CODE CLEAR IC. EXIT For Australian models The on-screen display also includes the following settings for your TV's remote control. • TV /VIDEO : Use to program the cyclic input selector button on your TV's remote. This allows you to switch the TV's input selector using this unit's remote. Do not program an independant input selector button at this setting. • WIDE TV DISPLAY MODE: Use to program TV mode button on your TV's remote. the - wide LEARNING SENSOR o •• •• Fri 0 TV's remote When registering the IR code, be sure to do the following; otherwise, the IR code may not be registered correctly. • Point the remote at the LEARNING SENSOR on the receiver from a distance of less than 4 inches (10 cm). • Hold down the button on the remote for about 2 or 3 seconds until the "RECEIVING" display switches to "RELEASE YOUR REMOTE". • Keep the remote pointed horizontally at the LEARNING SENSOR until the code is registered. 8 Repeat step 7 for the remaining buttons that appear in the on-screen display. If "NG" is displayed, an IR code was not registered correctly. In this case, repeat step 7 again. To return to the main menu Click EXIT. To return to a previous menu Click RETURN. cl To exchange from a non-Sony TV to a Sony TV Connect the receiver's MONITOR OUT jack to the VIDEO 1 input jack of the Sony TV. Follow the registration steps 1 to 3, then click SONY TV in step 4. Click VIDEO 1 2 3 and/or WIDE to specify VIDEO 1 and/or WIDE if necessary. Note Some IR codes may not have been successfully registered, even if "RELEASE YOUR REMOTE" appears on the TV screen. In this case, try registering the IR code again. If the IR code still cannot be registered, follow the procedure described in "Registering Desired Components (User IR setting)" on page 38. Erasing TV IR codes Click CODE CLEAR in the TV IR SET menuthat appears when you click START. • To erase a specific IR code 1 Click SINGLE IR CODE CLEAR. "SELECT CLEAR CODE KEY" appears. 2 Click the button you want to clear. "ARE YOU SURE?" appears. 3 Click YES to erase the code. To cancel erasing, click NO. To erase another code repeat steps 2 and 3. • To erase all the TV IR codes 1 Click TV IR CODE CLEAR. "ARE YOU SURE?" appears. 2 Click YES to erase the codes. "CODE CLEAR!" appears in the display. To cancel erasing, click NO.