TP-Link T1600G-52TSTL-SG2452 T1600G-52TS V1 CLI Reference Guide - Page 107
storm-control
View all TP-Link T1600G-52TSTL-SG2452 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 107 highlights
Example Set the storm control mode as pps on port 1/0/5: T1600G-52TS(config)# interface gigabitEthernet 1/0/5 T1600G-52TS(config-if)# storm-control pps 13.10 storm-control Description The storm-control command is used to enable the broadcast, multicast, or unicast strom control function and to set threshold levels on an interface. To disable the storm control function, please use no storm-control command. Syntax storm-control rate-mode { broadcast | multicast | unicast } { kbps | ratio | pps } { rate } no storm-control { broadcast | multicast | unicast } Parameter broadcast | multicast | unicast -- Enable broadcast/multicast/unicast storm control on the interface. kbps | ratio | pps -- Specify the storm control type. kbps: Specify the threshold in kbits per second. ratio: Specify the threshold as a percentage of the bandwidth. pps: Specify the threshold in packets per second. rate -- Specify the bandwidth for receiving packets on the port. The specified type of packet traffic exceeding the bandwidth will be discarded. For kbps, the rate ranges from 1 to 10000000 kbps. For ratio, the rate ranges from 1 to 100 percent. For pps, the rate ranges from 1 to 1488000 packets per second. Command Mode Interface Configuration Mode (interface gigabitEthernet / interface range gigabitEthernet / interface port-channel / interface range port-channel) User Guidelines Before you configure the storm-control type as kbps or ratio, pelease ensure that the port is not in pps mode. Example Configure the broadcast storm control rate as 1000 kbps on port 1/0/5: T1600G-52TS(config)# interface gigabitEthernet 1/0/5 T1600G-52TS(config-if)# storm-control rate-mode broadcast kbps 1000 95