TP-Link T1600G-52TSTL-SG2452 T1600G-52TS V1 CLI Reference Guide - Page 183
ipv6 mld snooping max-groups
View all TP-Link T1600G-52TSTL-SG2452 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 183 highlights
Syntax ipv6 mld snooping querier vlan vlan-id { query-interval interval | max-response-time response-time | general-query source-ip ip-addr } no ipv6 mld snooping querier vlan vlan-id { query-interval | max-response-time | general-query source-ip } Parameter vlan-id -- VLAN ID, ranging from 1 to 4094. interval -- The time interval to send a general query frame by MLD Snooping Querier, ranging from 10 to 300 (Seconds). By default, it is 60 seconds. response-time -- The maximal time for the host to respond to a general query frame, ranging from 1 to 25 (Seconds). By default, it is 10 Seconds. ip-addr -- The source IP of the general query frame sent by MLD Snooping Querier. It should not be a multicast IP or a broadcast IP. By default, it is fe80::02ff:ffff:fe00:0001. Command Mode Global Configuration Mode Example For VLAN 2, specify its query-interval as 200 seconds, and the response-time as 20 seconds: T1600G-52TS(config)#ipv6 mld snooping querier vlan 2 query-interval 200 T1600G-52TS(config)#ipv6 mld snooping querier vlan 2 max-response-time 20 22.14 ipv6 mld snooping max-groups Description The ipv6 mld snooping max-groups command is used to configure the maximum number of groups that a port can join in. The ipv6 mld snooping max-groups action is used to configure the action that the port takes when it receives an MLD report message and the maximum number of entries is in the forwarding table. To remove the maximum group limitation and return to the default of no limitation on the specified port, please use the no ipv6 mld snooping max-groups command. To return to the default action of dropping the report, please use the no ipv6 mld snooping max-groups action command. These commands only apply to the dynamic multicast groups. 171