TP-Link T2600G-52TS TL-SG3452 T2600G-28TS V1 CLI Reference Guide - Page 230
spanning-tree mode, spanning-tree mst configuration
View all TP-Link T2600G-52TS TL-SG3452 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 230 highlights
Command Mode Interface Configuration Mode (interface gigabitEthernet / interface range gigabitEthernet / interface port-channel / interface range port-channel) Example Enable the STP function of port 1, and configure the Port Priority as 64, ExtPath Cost as 100, IntPath Cost as 100, and then enable Edge Port: T2600G-28TS(config)# interface gigabitEthernet 1/0/1 T2600G-28TS(config-if)# spanning-tree common-config port-priority 64 ext-cost 100 int-cost 100 portfast enable point-to-point open 30.5 spanning-tree mode Description The spanning-tree mode command is used to configure the STP mode of the switch. To return to the default configurations, please use no spanning-tree mode command. Syntax spanning-tree mode { stp | rstp | mstp } no spanning-tree mode Parameter stp --Spanning Tree Protocol, the default value. rstp --Rapid Spanning Tree Protocol mstp --Multiple Spanning Tree Protocol Command Mode Global Configuration Mode Example Configure the spanning-tree mode as mstp: T2600G-28TS(config)# spanning-tree mode mstp 30.6 spanning-tree mst configuration Description The spanning-tree mst configuration command is used to access MST Configuration Mode from Global Configuration Mode, as to configure the VLAN-Instance mapping, region name and revision level. To return to the 214