TP-Link T2600G-52TS TL-SG3452 T2600G-28TS V1 CLI Reference Guide - Page 300
lldp snmp-trap, lldp tlv-select
View all TP-Link T2600G-52TS TL-SG3452 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 300 highlights
Example Enable Gigabit Ethernet port 1/0/1 to transmit LLDPDU: T2600G-28TS(config)# interface gigabitEthernet 1/0/1 T2600G-28TS(config-if)#lldp transmit 34.6 lldp snmp-trap Description The lldp snmp-trap command is used to enable the port's SNMP notification. If enabled, the port will notify the trap event to network management system. To disable the ports' SNMP notification, please use no lldp snmp-trap command. Syntax lldp snmp-trap no lldp snmp-trap Command Mode Interface Configuration Mode (interface gigabitEthernet / interface range gigabitEthernet) Example Enable the SNMP notification for Gigabit Ethernet port 1/0/1: T2600G-28TS(config)#interface gigabitEthernet 1/0/1 T2600G-28TS(config-if)#lldp snmp-trap 34.7 lldp tlv-select Description The lldp tlv-select command is used to configure TLVs to be included in outgoing LLDPDU. To exclude TLVs, please use no lldp tlv-select command. By default, All TLVs are included in outgoing LLDPDU. Syntax lldp tlv-select { [ port-description ] [ system-capability ] [ system-description ] [ system-name ] [ management-address ] [ port-vlan ] [ protocol-vlan ] [ vlan-name ] [ link-aggregation ] [ mac-phy-cfg ] [ max-frame-size ] [ power ] [ all ] } no lldp tlv-select { [ port-description ] [ system-capability ] [ system-description ] [ system-name ] [ management-address ] [ port-vlan ] [ protocol-vlan ] 284