TP-Link T2600G-52TS TL-SG3452 T2600G-28TS V1 CLI Reference Guide - Page 252

interval -- The time interval to send a general query frame by IGMP Snooping Querier, ranging from 10 to 300 (Seconds). By default, it is 60 seconds. response-time -- The maximal time for the host to respond to a general query frame, ranging from 1 to 25 (Seconds). By default, it is 10 Seconds. ip-addr -- The source IP of the general query frame sent by IGMP Snooping Querier. It should not be a multicast IP or a broadcast IP. By default, it is 192.168.0.1. Command Mode Global Configuration Mode Example For VLAN 2, specify its query-interval as 200 seconds, and the response-time as 20 seconds: T2600G-28TS(config)#ip igmp snooping querier vlan 2 query-interval 200 T2600G-28TS(config)#ip igmp snooping querier vlan 2 max-response-time 20 31.14 ip igmp snooping max-groups Description The ip igmp snooping max-groups command is used to configure the maximum number of groups that a port can join in. The ip igmp snooping max-groups action is used to configure the action that the port takes when it receives an IGMP report message and the maximum number of entries is in the forwarding table. To remove the maximum group limitation and return to the default of no limitation on the specified port, please use the no ip igmp snooping max-groups command. To return to the default action of dropping the report, please use the no ip igmp snooping max-groups action command. These commands only apply to the dynamic multicast groups. Syntax ip igmp snooping max-groups [ maxgroup ] ip igmp snooping max-groups action { drop | replace } no ip igmp snooping max-groups no ip igmp snooping max-groups action Parameter maxgroup -- Specify the maximum numbers of groups that the port can join. It ranges from 0 to 1000 and the default value is 1000. 236