TP-Link T2600G-52TS TL-SG3452 T2600G-28TS V1 CLI Reference Guide - Page 269
ipv6 mld snooping max-groups
View all TP-Link T2600G-52TS TL-SG3452 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 269 highlights
Example For VLAN 2, specify its query-interval as 200 seconds, and the response-time as 20 seconds: T2600G-28TS(config)#ipv6 mld snooping querier vlan 2 query-interval 200 T2600G-28TS(config)#ipv6 mld snooping querier vlan 2 max-response-time 20 32.14 ipv6 mld snooping max-groups Description The ipv6 mld snooping max-groups command is used to configure the maximum number of groups that a port can join in. The ipv6 mld snooping max-groups action is used to configure the action that the port takes when it receives an MLD report message and the maximum number of entries is in the forwarding table. To remove the maximum group limitation and return to the default of no limitation on the specified port, please use the no ipv6 mld snooping max-groups command. To return to the default action of dropping the report, please use the no ipv6 mld snooping max-groups action command. These commands only apply to the dynamic multicast groups. Syntax ipv6 mld snooping max-groups [ maxgroup ] ipv6 mld snooping max-groups action { drop | replace } no ipv6 mld snooping max-groups no ipv6 mld snooping max-groups action Parameter maxgroup -- Specify the maximum numbers of groups that the port can join. It ranges from 0 to 1000 and the default value is 1000. drop -- When the number of the dynamic multicast groups that a port joins has exceeded the max-group, the port will not join any new multicast group. replace -- When the number of the dynamic multicast groups that a port joins has exceeded the max-group, the newly joined multicast group will replace an existing multicast group with the lowest multicast group address. Command Mode Interface Configuration Mode (interface gigabitEthernet / interface range gigabitEthernet / interface port-channel / interface range port-channel) 253