TP-Link TL-SG5412F TL-SG5428 V1 CLI Reference Guide - Page 211
lldp timer
View all TP-Link TL-SG5412F manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 211 highlights
Command Mode Global Configuration Mode Example Specify Hold Multiplier as 5: TP-LINK(config)# lldp hold-multiplier 5 lldp timer Description The lldp timer command is used to configure the parameters about transmission. To return to the default configuration, please use no lldp timer command. Syntax lldp timer tx-interval tx-interval lldp timer tx-delay tx-delay lldp timer reinit-delay reinit-delay lldp timer notify-interval notify-interval lldp timer fast-count fast-count no lldp timer tx-interval no lldp timer tx-delay no lldp timer reinit-delay no lldp timer notify-interval no lldp timer fast-count Parameter tx-interval -- Configure the interval for the local device to transmit LLDPDU to its neighbors. By default, it is 30 seconds. tx-delay -- Configure a value from 1 to 8192 in seconds to specify the time for the local device to transmit LLDPDU to its neighbors after changes occur so as to prevent LLDPDU being sent frequently. By default, it is 2 seconds. reinit-delay --This parameter indicates the amount of delay from when LLDP status becomes "disable" until re-initialization will be attempted. The default value is 3. notify-interval -- Specify the interval of Trap message which will be sent from local device to network management system. By default, it is 5 seconds. fast-count --When the port's LLDP state transforms from Disable (or Rx_Only) 199