TP-Link TL-SG5412F TL-SG5428 V1 CLI Reference Guide - Page 80
arp detection recover
View all TP-Link TL-SG5412F manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 80 highlights
transmission speed of the legal ARP packet on the port exceeds the defined value. To restore to the default speed, please use no arp detection limit-rate command. Syntax arp detection limit-rate value no arp detection limit-rate Parameter value --The value to specify the maximum amount of the received ARP packets per second, ranging from 10 to 100 in pps(packet/second). By default, the value is 15. Command Mode Interface Configuration Mode(interface ethernet / interface range ethernet) Example Configure the maximum amount of the received ARP packets per second as 50 pps for the port 5: TP-LINK(config)# interface ethernet 5 TP-LINK(config-if)# arp detection limit-rate 50 arp detection recover Description The arp detection recover command is used to restore to the port to the ARP transmit status from the ARP filter status. Syntax arp detection recover Command Mode Interface Configuration Mode(interface ethernet / interface range ethernet) Example Restore the port 5 to the ARP transmit status: TP-LINK(config)# interface ethernet 5 TP-LINK(config-if)# arp detection recover 68