TP-Link TL-SG5412F TL-SG5428 V1 CLI Reference Guide - Page 56
LACP Commands, lacp system-priority, lacp (interface)
View all TP-Link TL-SG5412F manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 56 highlights
Chapter 10 LACP Commands LACP (Link Aggregation Control Protocol) is defined in IEEE802.3ad and enables the dynamic link aggregation and disaggregation by exchanging LACP packets with its partner. The switch can dynamically group similarly configured ports into a single logical link, which will highly extend the bandwidth and flexibly balance the load. lacp system-priority Description The lacp system-priority command is used to set the system priority. To restore to the default priority, please use no lacp system-priority command. Syntax lacp system-priority value no lacp system-priority Parameter value -- System priority, ranging from 0 to 65535. By default, the value is 32768. Command Mode Global Configuration Mode Example Set the system priority as1024: TP-LINK(config)# lacp system-priority 1024 lacp (interface) Description The lacp(interface) command is used to enable LACP protocol on the current port. To disable LACP protocol, please use no lacp command. Syntax lacp no lacp 44