TP-Link TL-WR902AC TL-WR902ACUS V3 User Guide - Page 141
DHCP, 7. 5. 1. DHCP Settings
![]() |
View all TP-Link TL-WR902AC manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 141 highlights
Chapter 7 Configure the Router in Client Mode • Password - Enter the password of the host network you want to connect to if it is encrypted. 7. 5. DHCP By default, the DHCP (Dynamic Host Configuration Protocol) Server is enabled and the router acts as a DHCP server; it dynamically assigns TCP/IP parameters to client devices from the IP Address Pool. You can change the settings of DHCP Server if necessary, and you can reserve LAN IP addresses for specified client devices. 7. 5. 1. DHCP Settings 1. Visit http://tplinkwifi.net, and log in with the username and password you set for the router. 2. Go to DHCP > DHCP Settings. 3. Specify DHCP server settings and click Save. • DHCP Server - Enable or disable the DHCP server. If disabled, you must have another DHCP server within your network or else you must configure the computer manually. • Start IP Address - Specify an IP address for the DHCP Server to start with when assigning IP addresses. 192.168.0.100 is the default start address. • End IP Address - Specify an IP address for the DHCP Server to end with when assigning IP addresses. 192.168.0.199 is the default end address. • Address Lease Time - The Address Lease Time is the amount of time a network user will be allowed to connect to the router with the current dynamic IP Address. When time is up, the user will be automatically assigned a new dynamic IP address. The range of the time is 1 ~ 2880 minutes. The default value is 120. • Default Gateway (Optional) - It is suggested to input the IP address of the LAN port of the router. The default value is 192.168.0.254. 134
![](/manual_guide/products/tplink-tlwr902ac-tlwr902acus-v3-user-guide-3550c82/141.png)