TP-Link TL-WR902AC TL-WR902ACUS V3 User Guide - Page 168
WPS, Channel, Channel Width, Enable SSID Broadcast, Wireless 2.4GHz/5GHz, Enabled, Add device
![]() |
View all TP-Link TL-WR902AC manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 168 highlights
Chapter 8 Configure the Router in Hotspot Router Mode • Channel - This field determines which operating frequency will be used. The default channel is set to Auto. It is not necessary to change the wireless channel unless you notice interference problems with another nearby access point. • Channel Width - Select any channel width from the drop-down list. The default setting is Auto, which can automatically adjust the channel width for your clients. • Enable SSID Broadcast - If enabled, the router will broadcast the wireless network name (SSID). 8. 3. 2. WPS WPS (Wi-Fi Protected Setup) can help you to quickly and securely connect to a network. This section will guide you to add a new wireless device to your router's network quickly via WPS. Note: The WPS function cannot be configured if the wireless function of the router is disabled. Please make sure the wireless function is enabled before configuration. 1. Visit http://tplinkwifi.net, and log in with the username and password you set for the router. 2. Go to Wireless 2.4GHz/5GHz > WPS. 3. Follow one of the following three methods to connect your client device to the router's Wi-Fi network. Method ONE: Press the WPS Button on Your Client Device 1. Keep the WPS Status as Enabled and click Add device. 2. Select Press the button of the new device in two minutes and click Connect. 161
![](/manual_guide/products/tplink-tlwr902ac-tlwr902acus-v3-user-guide-3550c82/168.png)