TP-Link TL-WR902AC TL-WR902ACUS V3 User Guide - Page 200
System Routing Table, 8. 12. Bandwidth Control, Enable Selected, Advanced Routing
![]() |
View all TP-Link TL-WR902AC manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 200 highlights
Chapter 8 Configure the Router in Hotspot Router Mode • Click Enable Selected to enable selected entries. • Click Disable Selected to disable selected entries. 8. 11. 2. System Routing Table 1. Visit http://tplinkwifi.net, and log in with the username and password you set for the router. 2. Go to Advanced Routing > System Routing Table, and you can view all the valid route entries in use. • Destination Network - The Destination Network is the address of the network or host to which the static route is assigned. • Subnet Mask - The Subnet Mask determines which portion of an IP address is the network portion, and which portion is the host portion. • Gateway - This is the IP address of the gateway device that allows for contact between the Router and the network or host. • Interface - This interface tells you whether the Destination IP Address is on the LAN & WLAN (internal wired and wireless networks), or the WAN (Internet). • Click Refresh to refresh the data displayed. 8. 12. Bandwidth Control 1. Visit http://tplinkwifi.net, and log in with the username and password you set for the router. 2. Go to Bandwidth Control. 3. Configure the bandwidth as needed and click Save. 193
![](/manual_guide/products/tplink-tlwr902ac-tlwr902acus-v3-user-guide-3550c82/200.png)