Yamaha LPX510 MCXSP10 Manual - Page 16

Basic Operations Adjusting the Screen Image You can adjust the screen image in order to obtain the best possible picture. Adjusting the Image Size (Zoom adjustment) The size of the projected image is basically determined by the distance from the projector to the screen. (Refer to the Setup Guide.) The following procedures explain how to adjust the screen image once the projector itself has been set up. 1 STANDBY/ON ESCAPE MENU PATTERN SETTING ASPECT INPUT ZOOM FOCUS IRIS SETTING PATT ESCAPE MENU Projector Remote control 2 STANDBY/ON ESCAPE MENU IRIS SETTING PATT ESCAPE MENU PATTERN SETTING ASPECT INPUT ASPECT LIGHT INPUT HIDE Projector Remote control Press the [SETTING] button on the projector's control panel or the ZOOM button on the remote control. An adjustment icon will be displayed over the image during projection. The adjustment mode changes as follows each time the [SETTING] button on the projector's control panel is pressed. Zoom → Focus → Iris Adjust the image size. If using the projector's control panel, press the or button to adjust the image size. If using the remote control, tilt the button to adjust the image size. Adjustment is also possible while a test pattern is being projected. (p.14) 3 STANDBY/ON ESCAPE MENU PATTERN SETTING ZOOM FOCUS IRIS SETTING PATT ESCAPE MENU ASPECT INPUT Projector Remote control Exit adjustment mode. Press the [ESCAPE] button on the projector's control panel or the ZOOM button on the remote control. When the electronic zoom lock is set to "ON", the projection size cannot be adjusted. The symbol will be displayed at this time. To carry out adjustments, change the electronic zoom lock setting to "OFF". (p.34) 11