Yamaha LPX510 MCXSP10 Manual - Page 37

Using the Menu Functions Main menu Setup Level *1 DVI-Video Level *1 Function (Setting is only possible when composite video or S-Video signals in NTSC format are being input or component video has been set. Setting is not possible when signals are being input from the HDMI port.) If using products designed for destinations such as the United States or South Korea that have different black level (setup level) settings, use this function to obtain correct images. Check the specifications of the connected equipment when changing this setting. (Setting is only possible when RGB video or computer signals are being input from the HDMI port.) If the projector's HDMI port is connected to the DVI port of a DVD player or similar equipment using an HDMI/DVI cable, set the video level for the projector to match the video level that has been set at the DVD player. The setting at the DVD player can be either Normal or Expand. Default setting 0% (Varies depending on country of purchase) Normal *1 The setting values are stored separately for each image source and signal type. Screen Main menu Function Position *1 (Setting is not possible when signals are being input from the HDMI port.) If using the projector's control panel, press the , , − and buttons to move the image display position. If using the remote control, tilt the button horizontally and vertically. Zoom Caption *1 If aspect is set to "Zoom" when viewing images with subtitles, change the setting as follows so that the subtitles are displayed. The vertical size and the display position can both be adjusted together. • Vertical Size The vertical size of the image is reduced so that the subtitles are displayed. Projection area Use "Vertical Size" to reduce the image size. Default setting Minimum value (0) • Zoom Position The whole of the image is moved up so that the subtitles are displayed. Subtitle section Use "Zoom Position" to change the display position of the image. Median value (0) Keystone Projection (If the aspect mode is set to "Smart Zoom", keystone correction cannot be set.) This is used to correct keystone distortion in images. The same correction can be carried out using the projector's control panel. (p.13) This should be set in accordance with the method used to set up the projector. •Front : Select when the projector is set up in front of the screen. •Front/Ceiling : Select when the projector is set up in front of the screen and suspended from a ceiling. •Rear : Select when the projector is set up behind the screen. •Rear/Ceiling : Select when the projector is set up behind the screen and suspended from a ceiling. Median value (0) Front *1 The setting values are stored separately for each image source and signal type. Advanced Operations 33