Yamaha SWR2311P-10G SWR2311P-10G Owners Manual - Page 28

Connections Connections ■ Connecting network devices, PoE powered devices, or a computer Using LAN cables, connect the LAN port of each device to the LAN ports of this unit. If using fiber optic cables to make connections, install an SFP module in an SFP port. For the installation procedure, refer to "Installing an SFP module" (page 28). Warning If you plan to connect a powered device that complies with the IEEE802.3at standards, use a CAT5e or higher-grade cable. Failure to use a standards-compliant cable for connection could result in a fire or malfunction. Notice The LAN ports and the RJ-45 CONSOLE port all use the same 8-pin connector. If you connect these wrongly, hardware damage or malfunction might occur. Take care when making connections. ■ Installing an SFP module The SFP ports accept installation of an SFP module (SFP-SWRG-LX, SFP-SWRG-SX). NOTE For details on installation, removal, and points of caution, refer to the "SFP-SWRG-LX SFPSWRG-SX Owner's Manual" included with the SFP module. 1. Remove the dust cover that is affixed to this unit's SFP port, and insert the SFP module. NOTE Since this unit supports hot-swapping, an SFP module can be installed without turning the power off. SFP port SFP-SWRG-LX SFP-SWRG-SX 2. Remove the protective cap from the SFP module. Protective cap Caution Do not look into the optical emitter when the SFP module is installed. The separately sold SFP modules are class 1 laser devices. They may emit laser beams invisible to the eye. If the laser beam enters your eye, your eyesight might be damaged. 28 SWR2311P-10G Owner's Manual