Yamaha SWR2311P-10G SWR2311P-10G Owners Manual - Page 32

Initialization ■ Using the cold start command to restore the factory settings You can return the unit to its factory settings by using a command line setting via the CONSOLE port, Telnet, or an SSH client. Here we assume that you are logged in as described in "Logging in from a computer connected to the CONSOLE port" (page 27). 1. Enter enable, and press the key. You are now in privileged EXEC mode. SWR2311P>enable SWR2311P# 2. Enter the cold start command, and press the key. You will be asked to enter the administrative password. If a password has already been specified, enter the password. When the unit is shipped from the factory, a password has not been specified, so it need not be entered. SWR2311P#cold start Password: 3. Press the key. The unit returns to the factory-set state, and then restarts. ■ Entering the (uppercase I) key during startup to restore the factory settings The unit can be restored to its factory settings by entering an uppercase when the unit is starting up. This explanation uses the method of disconnecting and reconnecting the power cord. The procedure is also the same when using the reload command to restart this unit. Notice Here we assume that you are logged in as described in "Logging in from a computer connected to the CONSOLE port" (page 27). 1. Disconnect and then reconnect the power cord of this unit. 2. During restart, enter an uppercase within one second after the BootROM Ver (see below) appears on the console screen. SWR2311P BootROM Ver.1.00 3. When a screen asks you whether to execute initialization, press the key to execute initialization. Initialize or not ?(y/n) Initialization is executed. Ready to Initialize 32 SWR2311P-10G Owner's Manual