Yamaha YSP-2700 Owners Manual - Page 101

Problem The Internet radio cannot be played. Cause The selected Internet radio station is currently not available. The selected Internet radio station is currently broadcasting silence. Access to the network is restricted by the firewall settings of your network devices (such as the router). The dedicated apps for mobile device does not detect the unit. The MAC address filter is enabled on the unit. The unit and mobile device are not in the same network. Firmware update via the network (Network Update) fails. It may not be possible depending on the condition of the network. The iPod does not recognize The unit and iPod/mobile device are connected to different SSIDs on the the unit when using AirPlay. same access point. The app installed on a mobile device does not recognize the unit. The unit cannot connect to the Internet via a wireless router (access point). The wireless router (access point) is turned off. The unit and the wireless router (access point) are too far apart. There is an obstacle between the unit and the wireless router (access point). Wireless network is not found. There is a device (microwave oven, wireless LAN, etc.) outputs signals in the 2.4 GHz frequency band nearby. Access to the network is restricted by the firewall settings of the wireless router (access point). Remedy There may be a network problem at the radio station, or the service may have been stopped. Try the station later or select another station. Some Internet radio stations broadcast silence at certain of times of the day. Try the station later or select another station. Check the firewall settings of your network devices. The Internet radio can be played only when it passes through the port designated by each radio station. The port number varies depending on the radio station. In "MAC Address Filter" in the setup menu, disable the MAC address filter or specify the MAC address of your mobile device to allow it to access to the unit. Check the network connections and your router settings, and then connect the unit and mobile device to the same network. Update the firmware via the network (Network Update) again or use a USB flash drive. See page - - - 83 - 92 Check the network connections for the unit and your mobile device, and connect them to the same SSID. - Turn on the wireless router (access point). - Place the unit and the wireless router (access point) closer to each other. - Move the unit and the wireless router (access point) in a location where there are no obstacles between them. - Move this unit away from the device that is emitting radio frequency signals. - Check the firewall setting of the wireless router (access point). - APPENDIX ➤ Troubleshooting En 101