Yamaha YSP-2700 Owners Manual - Page 33
Using AUTO SETUP IntelliBeam, connected p. 30.
![]() |
View all Yamaha YSP-2700 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 33 highlights
123456 Using AUTO SETUP (IntelliBeam) • Test tones output during measurement are loud. Perform AUTO SETUP when no children are around and there is no possibility of their entering the listening room, as their hearing may be impaired. • If there are curtains in your listening room, we recommend following the procedure below. 1. Open the curtains to improve sound reflection. 2. Run "Beam optimize only" (p. 35). 3. Close the curtains. 4. Run "Sound optimize only" (p. 35). • Make sure that your listening room is as quiet as possible. For accurate measurement, turn off air conditioner or other devices that make noises. 1 Turn the unit and your TV on. 2 Switch TV input to the input jack (HDMI 1, etc.) to which this unit is connected (p. 30). 3 Connect the IntelliBeam microphone to the INTELLIBEAM MIC jack on the rear panel of the unit. IntelliBeam microphone Cardboard microphone stand INTELLIBEAM MIC The screen below is displayed after connecting IntelliBeam microphone to the unit. "AUTO SETUP" in the "IntelliBeam" menu can automatically adjust the following two settings. Beam optimize only This feature optimizes the beam angle so that the parameter best matches your listening environment. Sound optimize only This feature optimizes sound quality for each channel by measuring the acoustic characteristics of the listening environment. "Beam optimize only" or "Sound optimize only" can be measured separately in the setup menu (p. 35). • Follow the instructions below and then leave the room. If you remain in the room, you may obstruct the beam, or the microphone may pickup any sounds you make, possibly resulting in improper measurement. PREPARATIONS ➤ f Initial settings En 33
![](/manual_guide/products/yamaha-ysp2700-owners-manual-cd11c9d/33.png)