Yamaha YSP-2700 Owners Manual - Page 38
HDMI1, Changing the HDMI control function, Changing the connection method and, connected devices
![]() |
View all Yamaha YSP-2700 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 38 highlights
123456 z HDMI 1 Changing the HDMI control function If you are unable to operate the unit with your TV's remote control, configure the HDMI control function as follows. 1 Turn on the unit, TV, and playback devices. 2 Enable the HDMI control function on the unit, TV, and playback devices such as BD/DVD players that support this function. For this unit, confirm that "HDMI Control" is set to "On" (default setting) (p. 80). Enable the HDMI control function on the TV and playback devices. Refer to documentation supplied with the TV or playback devices for details. 3 Turn off the main power of the TV and then turn off the unit and playback devices. 4 Turn on the unit and playback devices and then turn on the TV. 5 Switch TV input to the input jack (HDMI 1, etc.) to which this unit is connected. 6 Select HDMI 1-3 as an input source and confirm that the video of the playback device is displayed on the TV. When the playback device is connected to the HDMI IN 1 jack, press the HDMI1 key. HDMI1 Input source name 7 Check that the unit is properly coordinated with the TV by turning off the TV or adjusting the TV volume with the TV remote control. If devices are not coordinated Confirm the settings are properly configured as described below. - "HDMI Control" (p. 80) is set to "On" in the setup menu. - The HDMI control function is enabled on the TV. Examples of TV settings • From the setup menu on your TV, select "Link setting" "HDMI control setting", then set a setting such as "HDMI control function" to "ON". • Set audio output to any option other than TV. • Contact the manufacturer of your television for TV settings. If devices fail to coordinate even after the settings described above have been applied correctly: - Turn off this unit and the TV, and then turn them back on again. - Disconnect the power cable of the unit and external devices connected to the unit via HDMI cable. Plug them in again after about 30 seconds. - If devices fail to coordinate after TV, AUX1, or AUX2 is input, repeat steps 5 and 6 under "Changing the HDMI control function". Changing the connection method and connected devices When changing connected devices, or the jacks via which devices are connected, reconfigure settings as follows. 1 Disable the HDMI control function of the TV and BD/ DVD player, turn off all connected devices, and change the connections. 2 Perform steps 1 to 7 of "Changing the HDMI control function". PREPARATIONS ➤ f Initial settings En 38
![](/manual_guide/products/yamaha-ysp2700-owners-manual-cd11c9d/38.png)