ZyXEL NBG5615 User Guide - Page 66
Setting your NBG5615 to AP Mode, 8.3.2 Accessing the Web Configurator in Access Point Mode
View all ZyXEL NBG5615 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 66 highlights
Chapter 8 Access Point Mode 8.3.1 Setting your NBG5615 to AP Mode 1 Log into the Web Configurator if you haven't already. See the Quick start Guide for instructions on how to do this. 2 To use your NBG5615 as an access point, go to Maintenance > Sys OP Mode and select Access Point Mode. Figure 39 Changing to Access Point mode Note: You have to log in to the Web Configurator again when you change modes. As soon as you do, your NBG5615 is already in Access Point mode. 3 When you select Access Point Mode, the following pop-up message window appears. Figure 40 Pop up for Access Point mode Click OK. Then click Apply. The Web Configurator refreshes once the change to Access Point mode is successful. 8.3.2 Accessing the Web Configurator in Access Point Mode Log in to the Web Configurator in Access Point mode, do the following: 1 Connect your computer to the LAN port of the NBG5615. 2 The default IP address of the NBG5615 is "192.168.1.2". In this case, your computer must have an IP address in the range between "192.168.1.3" and "192.168.1.254". 3 Click Start > Run on your computer in Windows. Type "cmd" in the dialog box. Enter "ipconfig" to show your computer's IP address. If your computer's IP address is not in the correct range then see Appendix B on page 221 for information on changing your computer's IP address. 4 After you've set your computer's IP address, open a web browser such as Internet Explorer and type "192.168.1.2" as the web address in your web browser. 66 NBG5615 User's Guide